Siser Metal Bronze

Application instructions (home iron)
• Set iron dial between Cotton and Linen
• Cover design with Kraft paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 5-10 seconds
• Peel carrier cold

Application Instructions (heat press)
• Cut in reverse
• Weed excess material
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• Peel carrier cold

 Metal Applies to:

100% cotton
Poly/cotton blends
100% polyester

Laundering:

Wait 24 hours before 1st wash
Machine wash cold / mild detergent
Hang item to dry
Do not dry clean

Cricut:

Blade: Standard
Setting: Iron On

Silhouette Cameo:

Blade: Standard, 2
Material: Heat Transfer, Smooth
Speed: 8
Force: 6

Scan N Cut:

Blade: Standard, 2
Cut Speed: 1
Cut Pressure: 3

Roland GS/GX-24:

Blade: 45°
Gram Force: 80-90
Offset: .250
Speed: 30-50 cm/s

Graphtec:

Blade: 45°
Gram Force: 8-9
Tool: CB09U+0
Speed: 30 cm/s

MH, SC2, LP3, and Titan 1:

Blade: 45°/60°
Gram Force: 85-90
Speed: 300mm/s
*Blade Advancing Varies

Titan 2 & 3:

Blade: 45°/60°
Gram Force: 65-70
Speed: 300mm/s
*Blade Advancing Varies

Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.